Vibration Training Kit Advanced
Advanced Rotor Kit for test and measurements to support practical training of vibration signals, bearings faults detection and single and two plane balancing job. Rotor kit is based on aluminium plate with rubber dampers.
The drive is made of low power 3 – phase electric motor and frequency inverter for START, STOP and continuous shaft speed control with safety switch near by. Clutch drives rotor with discs from 0 RPM up to 1480 RPM. Discs has threaded holes around different diameters for trial and balancing masses. Shaft is based on two main ball bearings.
Flat spot with thread is prepared on top of all bearing’s housing for accelerometers. Rotational part has cover made of aluminium frame and transparent barrier to protect operators when rotor runs. Cover has open top to fit accelerometer with connector.
- 1 phase power supply
- Quick installation
- Simulation a real industrial machine
- Operational safety (safety stop and protection cover)
- Spots for accelerometers
- Single and two plane balancing
SPECIFICATION:
Power supply: ~230 V, 50 Hz
B1: Rolling element defect
B2: No defect
B3: Outer race defect
Speed: 0..1480 RPM
Safety button: 2 sides
Green button: START
Red button: STOP
Prepared mouting positions for vibration sensors: 1/4 – 28 UNF
Tacho output: M12 5Pin
Dimensions (w x d x h): 1000 x 290 x 380 mm
Weight: ~ 50 kg
Reviews
There are no reviews yet.